Subject: Turbo Rx8 carb draw through style
From: paul lamar
Date: 6/16/2017, 3:24 PM
To: A10-Me-Earthlink



   I hate to lower the level of intelligence here but is it ok to use a GT45 with a holley carb draw through style . The fuel itself would help cool things down wouldn't it?

   Any intake manifold pressure relief would have to be exited to the outside of the cowl or perhaps back into the end of the exhaust .
   Wastegate alternative as described by you Paul could still be the same.

   My other thought was towards the propeller. Is there a propeller that could take 350hp and be ground adjustable to soak up 650 hp at a latter date?

   Hope I am not to far off the planet. Its all new stuff to me

   Mark Dillner


    I built a 3 rotor version but so far I did not run it. So I have no experience.
   Here are a few pictures. I'll sell the carb if you want to buy it.

   Paul Lamar

Draw through needs seals on the compressor side of the cartridge so you do not suck oil through during low throttle opening operation. Blow through does not have the same issue. With blow through you need either a pressure box the carb is in so it is surrounded by pressurized air. The other way is to drill into the shaft bores for the throttle plates and duct boost air to them to "seal" the shafts or fuel will leak out. Either way, blow through fuel pressure needs to be about 5 PSI above boost pressure. The float bowl vent must be under boost or it will blow fuel out there. Draw through is simpler as long as the turbo is built for that.

Dale Davies

Good point Dale.

Paul Lamar

   The Rotary Engine free News Letter. Powered by Linux. If you want off
   the list PLEASE let me know and I will remove  you.  ACRE NL web
   site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2017 All world wide rights reserved.