Subject: Turbo Rx8 carb draw through style
From: paul lamar
Date: 6/16/2017, 4:16 PM
To: A10-Me-Earthlink


I hate to lower the level of intelligence here but is it ok to use a
GT45 with a holley carb draw through style . The fuel itself would help
cool things down wouldn't it?

Any intake manifold pressure relief would have to be exited to the
outside of the cowl or perhaps back into the end of the exhaust  .
Wastegate alternative as described by you Paul could still be the same.

My other thought was towards the propeller. Is there a propeller that
could take 350hp and be ground adjustable to soak up 650 hp at a latter
date?

Hope I am not to far off the planet. Its all new stuff to me

Mark Dillner


  I built a 3 rotor version but so far I did not run it. So I have no
experience.
Here are a few pictures. I'll sell the carb if you want to buy it.


Paul Lamar


I think it's way to early for me to be buying those parts yet Paul.
I started thinking if I could have a reliable 350 hp it would pull my BD4 upwards ,as they say, like a homesick angel and if then with an even larger Holley or maybe just opening the secondary's the cfm would be large enough to pull double that.
However, the length, pitch or number of blades required to soak up the power may be way past my pocket savings.


That is the great thing about the Mazda. It has the reserve capacity to upgrade way past what is normally possible with any reliability so I shall stick with it. No other engine is going to give me the flexibility or reliability of the rotary.


That's why I figure I should start with large turbo ,large Holley four barrel so it can perhaps be used as a two barrel until time comes to up the HP and prop size.
You did say what prop is used on the TTC and maybe I should watch out time to time for something in that range to pop up .
As I said it's new to me but I have made parts before . I used to rebuild MGB's into a Sebring style and I made my own gas (lpg) carburettor and suspension parts  for my 65 Mustang 302 so  I can nut a few things out.

Mark Dillner

I think my Holley is 750 CFM.

I used to have a Sprite a long time ago. The most amazing things broke.
How about a cracked rear brake cylinder :-)

I did an XKE hood for it.

Paul Lamar



The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.