Subject: Turbo Rx8 carb draw through style
From: paul lamar
Date: 6/16/2017, 4:35 PM
To: A10-Me-Earthlink



   I hate to lower the level of intelligence here but is it ok to use
a GT45 with a holley carb draw through style . The fuel itself would
help cool things down wouldn't it?

   Any intake manifold pressure relief would have to be exited to the
outside of the cowl or perhaps back into the end of the exhaust .
   Wastegate alternative as described by you Paul could still be the same.

   My other thought was towards the propeller. Is there a propeller
that could take 350hp and be ground adjustable to soak up 650 hp at a
latter date?

   Hope I am not to far off the planet. Its all new stuff to me

   Mark Dillner


     I built a 3 rotor version but so far I did not run it. So I have
no experience.
   Here are a few pictures. I'll sell the carb if you want to buy it.

   Paul Lamar

Draw through needs seals on the compressor side of the cartridge so you
do not suck oil through during low throttle opening operation. Blow
through does not have the same issue. With blow through you need either
a pressure box the carb is in so it is surrounded by pressurized air.
The other way is to drill into the shaft bores for the throttle plates
and duct boost air to them to "seal" the shafts or fuel will leak out.
Either way, blow through fuel pressure needs to be about 5 PSI above
boost pressure. The float bowl vent must be under boost or it will blow
fuel out there. Draw through is simpler as long as the turbo is built
for that.

Dale Davies

Good point Dale.

Paul Lamar


Do you know if seals  can be fitted to the Garret GT40 or 45?

If so what sort of material are they as it must be pretty darn hot in there?

Mark Dillner


No I nothing about that.


Paul Lamar



The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.