Subject: We flew the TTC again today video
From: paul lamar
Date: 9/2/2017, 5:35 AM
To: A10-Me-Earthlink



We got up to 10,000 feet. Full throttle and a small amount of waste gate closure.
We will have more engine data tomorrow.

This take off video is only 25 seconds and my guess is it ends at 3000 to
4000 feet. The aircraft  is just a speck at that point.

I am not sure as the guys forgot the camera looking at the altimeter.

The angle of climb is about 80 to 90 degrees. Near vertical.
Dan says it is real critical. He has no visual reference so we are going
to put an aerobatic device on the left wing so he has a visual angle  reference.

It is doing about 110 Kt at that angle.

110 Kts is 126 MPH or is 184 FPS or 11,000 feet per minute.
Check my arithmetic.

It appears the record is a piece of cake if we can climb near vertically
at 110 Kts. In fact we would push it so far out of sight no other
engine would equal it other than another Wankel.


We had a problem with the RV8 chase plane as the alternator failed
and it did not have mags. It had something called e-mags.

Of course it can't climb  near as fast as the Wankel so the Wankel
loses it anyway..

Paul Lamar

What a Day for Rotary Engine Followers, keep looking for my Love emote
key from Facebook. Will their be a better camera system on the final go
for the record run ???

George F. Curtis Jr.

As per normal your math is spot on,
Calculating 1 Kts = 1.687xx ft/sec you get 11,134 ft/ min @ 110 Kts.
Ignoring the altimeter and taking an 80 degree climb angle you must travel 10,200 ft to climb 10,000 ft AGL.
All being well you have it in the basket.
Could you not use a pendulum inside the cockpit? Once acceleration has stopped it would measure your climb angle.
Good fortune

Andrew. Campbell


Yes that might work. I'll suggestion it to the captain.

Here is a medium rez vid of the start of the  pitch up. Highest rez I have.

 The throttle was fed in gradually  over a period
of   24 seconds. Time of full throttle after that was 108 seconds
at 8000 RPM. The prop tips are near supersonic at 2666 RPM.

After this here is some of the data.
Max manifold pressure 60 inches of HG. Blow off valve setting.
Throttle wide open. RPM 8000.
Max engine oil temperature 205 F peak.

I will add another spring to the blow off valve to up it at least
another 15 inches of Hg. It is as highest it can go with the current spring.

I don't have a higher rez camera.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.