Paul,
No, the cover is slightly different and the remote water pump has been
replaced with the original and a highly modified housing.
I found an old pic with the engine out of the airframe and this was when I
was going to use Tracy's EC-4 single processor box. This is the same cover
that is on there now and would be used for the CDI MaxiMite scenario.
Joe Berki
I see where the water pump belt was interfering.
That will work. You have to move the CAS counter clockwise that is in there
now and make a one tit trigger plate with slots. and then add the second CAS
180 degrees.
You are getting close.
Do you know how to find top dead center?
Paul Lamar
Paul,
There are 2 marks on the pulley red and white.
When the hub keyway is at 9:00 the white mark lines up with the pointer.
Is that TDC or something else?
What does the red mark mean?
Trigger wheel could be 3/8' aluminum plate cut with a 5" hole saw and a
center hole cut with a 1 7/8" hole saw.
Drill the 4 mounting holes which have an unusual pattern so you can install
in the correct orientation.
Drill and tap a hole in the ring at 20 degrees BTDC and install a steel
screw.
Drill and tap a hole 180 degrees from the steel screw and install a brass
screw that weighs the same as the steel one.
Thanks.
HOw do you find top dead center?
David Miksell
San Jose,CA
Joe Berki
That's great if you can take the bolt holding the front hub on the e-shaft
off to see the keyway. Don't pull the hub unless you are prepared to
reset the e-shaft thrust bearing. It is true the keyway is at 9 o-clock when
the rotor is top dead center at 3 o-clock. I have two pulleys with notches.
The first notch is at zero or 12 o-clock and the second notch is about
11:30 or so o-clock. That may be the signal to the computer to fire
the ignition however I am not sure. They never ever publish the source
code to their software :-)
Just about all the engines I have have these features. However
the CAS can be located anywhere if the trigger plate is rotated.
The RX8 case is 4:30.
Make a short length of wood dowel that just slips in the lower spark
plug hole. As you rock the engine over back and fourth near TDC the
dowel will
come out and go back in. Max in is TDC. That is rather a crude way.
Another way is brake a spark plug ceramic and make a fitting for
a transparent hose. Fill the combustion chamber with oil and hold
the hose vertical. The oil will go up and down in the hose. When it
goes to peak height that is TDC. Max compression.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove you. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Copyright
1998-2017 All world wide rights reserved.