Subject: helicopter with a vertical rotary 13b engine
From: paul lamar
Date: 9/15/2017, 6:37 AM
To: A10-Me-Earthlink



   Hi Paul,

   would like to receive your news letter .

   I was a previous receiver of your newsletter and I would like to subscribe. To your news letter .

   I will shortly  have a new e-mail address dedicated to receiving your news letters .

   I am designing a helicopter with a vertical rotary 13b engine. This has been a lot of fun and dedicated hard work which causes me to revisit and rework the design- many changes have been made since the beginning.

   Kind regards

   George Crooks

    Your on the bleeding edge there George. The weights of the rotors on the
   end housing may cause increased wear.

   The oil drain back from the cooling oil squirted into the rotors to cool them
   may not drain back properly. You will need a dry sump system for sure.

   On the positive side there are several companies in Oz making aluminum
   end housing.  We are getting 650 HP and the engine weight with the turbo is under
   200 pounds. We are using Iannetti apex seals and the engine is incredibly
   robust with 60 inches of Hg at 8000 RPM with 300 F intake air going into
   to the engine.

   That would blow a piston engine to smithereens.

   Paul Lamar

A more robust thrust bearing may be required also to deal with the continual weight of the eshaft with all other components bolted to it.

Dale Davies


   The Rotary Engine free News Letter. Powered by Linux. If you want off
   the list PLEASE let me know and I will remove  you.  ACRE NL web
   site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2017 All world wide rights reserved.