Subject: Beveled rotor long sides
From: paul lamar
Date: 9/18/2017, 11:24 AM
To: A10-Me-Earthlink



   Good tip!

   Would you have any comments about Rotors  having beveled corners, I
   meaning the long sides of chamber side of rotor having an oblique cut
   instead of a straight angle?

   Thanks, regards. Salut +


   Jose Gros-Aymerich

     Madrid, Spain

   What do you hope to gain?

   I see no advantage in doing that. You risk affecting the side seal
   effectiveness.

   Paul Lamar


For side ported engines. That bevel or chamfer is used to increase port timing while not changing the runner opening into the chamber. Opening the runner face or "port" in order to change intake timing increases the port cross section which reduces velocity at the port face. Not important on boosted engines but used on NA engines for very high RPM applications like drag racing where shifting above 11,000 RPM is used.
So, you can maintain the highest possible port velocity And, increase effective port timing. There will be a slight loss of compression, but the increase in charge volume makes up for it.  Of no value in a street engine or for aviation.

Lynn E. Hanover

P-port is the way to go for aviation. We idle at 2000 RPM and rarely get below 5000 RPM
for cruise.

Paul Lamar

         The Rotary Engine free News Letter. Powered by Linux. If you want off
         the list PLEASE let me know and I will remove  you.  ACRE NL web
         site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
         Copyright 1998-2017 All world wide rights reserved.