Paul,


I set up the aluminum disc and taped a nut to the circumference and position the RX-8 sensor and connected it to a scope.

This was chucked up into an old drill press and I measured the spindle speed with an optical tach from Harbor Freight.

The 500 rpm speed yielded a 2.5 volt pulse and a 4.25 volt pulse at 1350 rpm.

I was testing a 2^nd gen CAS using the same setup and got similar results and when I connected it to the  Zeal Daughter board it cleaned it up and kept the pulses at the same voltage level.

Currently working on brackets to position the sensors out of the way and 180 degrees apart.


Joe Berki

Good work Joe.

When you feed this into a LM1815 you get a nice positive going narrow rectangular
wave out at a constant 5 volts high.


Paul Lamar

he Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.