| Subject: Electric oil pump and coolant pump power requirement |
| From: paul lamar |
| Date: 9/30/2017, 11:20 AM |
| To: A10-Me-Earthlink |
Paul, and group
We are thinking of building a 13B engine for our airplanes and
possibly for my helicopter project.
We are contemplating using an electric coolant pump and also an
electric oil pump.
We were thinking of using the Toyota MR2 power steering pump for
oil, and some other, like a Messiere type pump for the coolant.
Do you know the power requirements for these two pumps?
We have already used an MR2 oil pump for our electric car project.
Zoltan Szakaly and Mark Szakaly
Yes and an electric cooling pump is a bad joke. It takes 3 HP to cool
a rotary. 2,250 watts at 12 volts that is 187 AMP!!!!! The fuse on
a Mezziewr is 20 amps. Good luck :-)
Paul Lamar
I wonder if you have any information on the oil pressure and flow
rates? I imagine the oil pump is just driven by the engine directly
and so it is hard to get any data on it. I would just like to get
your ideas of the oil pressure and amount of oil used. I know that
you have an oil pan you developed. How long does it take to fill up?
Thank you for your response.
Zoltan Szakaly
Thank you for your quick response.
You have answered my question regarding the coolant flow
requirement.
But what is the necessary oil pressure and oil flow requirement? What
is the meaning of the colors on your coolant flow diagram?
Zoltan Szakaly
As I recall the old stock engine of around 150 HP used 30 gallons
an hour. I would up that as we are talking a lot more HP
Paul Lamar
To measure the oil flow you would need to install a flow measurement device between the pump and the engine. Remember the pressure regulator dumps excess oil to the pan or tank. Best would be to measure both to determine what is actually happening in the oil system.Of course the pump flow rate can be calculated considering pump RPM, but the important information is the actual flow to the engine.
Also remember the pressure regulator only limits maximum oil pressure. Before the pressure regulator opens the pressure is determined as a balance of pump flow restricted by bearing clearances and cooling squirter. Thus worn bearings will create pressure issues at low pump flow rates as at idle.
Ford Cleveland and Modified engines were notorious for this. At about 100k miles the oil light would start to flash after driving a few miles and stopping at a light or stop sign. People would come in to have the oil pump replaced. I would replace the worn main and conn rod bearings and while mostly there, replace the timing chain with a double roller chain assembly. Good for another 100k miles.customer would be mad I did not replace the pump. I always inspected them and determined they were serviceable. Offered to replace the pump if they were not satisfied after driving it, for free. Never had to do that.
Dale Davies
I wish we had a flow rate sensor on the TTC engine.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove you. ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.