Subject: Electric oil pump and coolant pump power requirement
From: paul lamar
Date: 9/30/2017, 8:15 PM
To: A10-Me-Earthlink



Paul, and group

We are thinking of building a 13B engine for our airplanes  and
possibly for my helicopter project.

We are contemplating using an electric coolant pump and also an
electric oil pump.

We were thinking of using the Toyota MR2 power steering pump for
oil, and some other, like a Messiere type pump for the coolant.

Do you know the power requirements for these two pumps?

We have already used an MR2 oil pump for our electric car project.

Zoltan Szakaly and Mark Szakaly

Yes and an electric cooling pump is a bad joke. It takes 3 HP to cool
a rotary.  2,250 watts at 12 volts that is  187 AMP!!!!! The fuse on
a Mezziewr is 20 amps. Good luck :-)

Paul Lamar


I wonder if you have any information on the oil pressure and flow
rates? I imagine the oil pump is just driven by the engine directly
and so it is hard to get any data on it. I would just like to get
your ideas of the oil pressure and amount of oil used. I know that
you have an oil pan you developed. How long does it take to fill up?
Thank you for your response.

Zoltan  Szakaly


       Thank you for your quick response.

You have answered my question regarding the coolant flow
requirement.

But what is the necessary oil pressure and oil flow requirement? What
is the meaning of the colors on your coolant flow diagram?

       Zoltan  Szakaly

       As I recall the old stock engine of around 150 HP used 30 gallons
       an    hour.   I would up that as we are talking a lot more HP


       Paul Lamar

   Thank you for all this valuable information.
   Zoltan  Szakaly

   Your welcome.

   Paul Lamar


Old cars had 20 to 40HP and got down the road fine. New cars have a much lower CD so should reqire less power. When you have a car capable of 400HP you are still using only 40 HP driving down a level highway.

Caterpillar had an engine that was also used in trucks. Small V8 with max HP of 225. One compression ring, one oil ring. Used in dump trucks and Massey tractors they worked good. The dump trucks worked hard loaded nut then had it easy returning empty. Some guys would spec a truck with one and hook onto a 45'van and head to Florida or California. They would take #7 and #8 rod bearings out. We could do the same on the dyno in 2 hours at rated HP. We started de-rating them to 215HP and they lasted. Cat came out with essentially the same engine using a new model number but rated at 215HP.

It all comes down to application!

Dale Davies


The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.