Subject: dry-sump-tank for TTC
From: paul lamar
Date: 11/2/2017, 9:45 PM
To: A10-Me-Earthlink

We where having serious oil problems the last few times
Dan flew it. The last flight we lost a full gallon and a half over board.
Despite that it took only 1 minute 47 seconds to get to 10k
and best the record.

The oil pressure started at about 120 psi and by the time Dan
got to 10,000 feet it was down to 50 psi. As soon as he leveled
off it rose back to 120 psi. I suspected pump caviatation as
the intake was about 3 feet below the oil pressure pump
when the airplane had a 45 degree nose pitch up angle.

The two problems were not necessarily related.

One of the fittings on the tank, being used for the vent line,
had damaged threads. Somebody cut the vent hose fitting nut
down to compensate. That was a new trick on me. No matter
your age and experience there is always something  new to learn :-)

It worked as long as it was tight but it did not take much to
loosen it. I believe thats how we got a half gallon of oil in
the bottom of the fuselage :-)

It just so happened I had a steel -12 AN fitting so I screwed
that on and it cleaned up the aluminum threads.

It is 1" & 5/16" by 12 threads per inch which just so happens to
be the same size nut that holds the wheels on a tractor trailer truck :-)

You can get steel dies in that size but  they cost over $50.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.