12 a
Paul,


Is the diameter of the passage indicate on the attachment the same diameter
as Tom's leaning kit?  Would it be appropriate for a venture to be added to
the center of each inlet?  Holley makes venture booster for its racing
carbs.  Is there a recess passage for fuel to run around the perimeter of
the inlets?  Would the clamping method be prone to leaking?  Can the float
bowl be higher than the inlets? Thanks Joe Berki


All the passages in the Holly are the same as the leaning kit..

The clamping method are screws. The same as the Holly carb.

You can add an aux  venture if you want but the opening is a venture,

The recess is to fit the 2 inch intake runner. It is tig welded.

Paul Lamar
Paul,
If I need to change the configuration can the float bowl be located above
the inlets? Joe Berki

No! The float level position relative to the Venture vent is critical.

The whole idea here is to get this under the cowl of most front engine
p-ports with a high mounted engine.  The distance from the thrust line to the ground limits
your prop diameter.

The stock two barrel Holly down draft is too high.

If you drop the float bowl down it will interfere with the rotor housing.
Then of course you would have to redrill the venture vent holes.

Paul Lamar


Please  add your add your questions or comments  at the end of the thread.
Not the begging.

I am going to enforce that rule. If people don't do that it will not be
forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove  you.  ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas Copyright
1998-2017 All world wide rights reserved.