12
Paul,


Is the diameter of the passage indicate on the attachment the same diameter as Tom’s leaning kit?  Would it be appropriate for a venture to be added to the center of each inlet?  Holley makes venture booster for its racing carbs.  Is there a recess passage for fuel to run around the perimeter of the inlets?  Would the clamping method be prone to leaking?  Can the float bowl be higher than the inlets? Thanks Joe Berki


All the passages in the Holly are the same as the leaning kit..

The clamping method are screws. The same as the Holly carb.

You can add an aux  venture if you want but the opening is a venture,

The recess is to fit the 2 inch intake runner. It is tig welded.

Paul Lamar


Please  add your add your questions or comments  at the end of the thread.
Not the begging.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.