Subject: coupling for my single rotor 12 d
From: paul lamar
Date: 11/16/2017, 9:54 PM
To: A10-Me-Earthlink



12 d

Hi Paul,


This is the cush drive I have built for my single rotor.

It is machined out of 6061T6 billet on an old lathe and cheep
Chinese mill. The diameter is approx 4.7 inches, the inserts are
urethane rod at 1.25 inches in diameter. I am going to start with the
green urethane which is the lowest Shore hardness available here. the
photo shows a yellow grade which is slightly harder. The rod cuts
well with a sharp tungsten blade on a drop saw.

I have also had a new flywheel machined from billet 4140, as I was
not happy with the flex plate. The whole assembly has been
dynamically balanced.

Andrew Campbell.


Yes. That looks like it is going to work. Good idea. You should use
silicone rubber. Good to 500 F. There is a certain amount of energy
going into those dampers.

Urethane is only good to about 200 F.

Paul Lamar

Andrew,


Your side housings appear to be aluminum........Are they locally
sourced or "Racing Beat housings" ??

Thanks,
   Yes they are aluminum from Racing Beat, the stationary gear has had
extra  holes drilled for the aluminum.
   Andrew.



------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.