12 b
Paul,
Is the diameter of the passage indicate on the attachment the same diameter
as Tom's leaning kit? Would it be appropriate for a venture to be added to
the center of each inlet? Holley makes venture booster for its racing
carbs. Is there a recess passage for fuel to run around the perimeter of
the inlets? Would the clamping method be prone to leaking? Can the float
bowl be higher than the inlets?
Thanks Joe Berki
All the passages in the Holly are the same as the leaning kit..
The clamping method are screws. The same as the Holly carb.
You can add an aux venture if you want but the opening is a venture,
The recess is to fit the 2 inch intake runner. It is tig welded.
Paul Lamar
Paul,
Are the ventures your bell mouths that you have on your web page?
Joe Berki
No. They must be machined into that front plate. You can do it with a rotary
table and a radius cutter.
Paul Lamar
Paul,
What is the thickness of the aluminum block that the body is machined from?
What radius did you specify for the venture? I ordered a mixture kit from
Tom. Joe Berki
5/8th of an inch. 1/2 inch for the radius.
I suggest you get Rhino.
Paul Lamar
Paul,
I took the drawing to a machine shop and they are looking at how to do it.
Do you think that a primer circuit will be required? The hole drilled into
the sides to permit rifle drilling the block could be used. Would the primer
hardware be the same as used on lycomings?
Joe Berki
That primer is a good idea for use with the side draft Holley.
You are a pioneer on this Joe so expect to do a few fixes
here and there. You can probably sell them to the rotary
automotive fans.
Paul Lamar
------------------------------------------------------------------
Please add your questions or comments at the end of the thread.
Not the beginning.
I am going to enforce that rule. If people don't do that it will not be
forwarded.
My ISP changed the rules.
The Rotary Engine free News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove you. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Copyright
1998-2017 All world wide rights reserved.