12 d
Paul,
Is the diameter of the passage indicate on the attachment the same
diameter as Tom's leaning kit? Would it be appropriate for a venture
to be added to the center of each inlet? Holley makes venture
booster for its racing carbs. Is there a recess passage for fuel to
run around the perimeter of the inlets? Would the clamping method be
prone to leaking? Can the float bowl be higher than the inlets?
Thanks Joe Berki
All the passages in the Holly are the same as the leaning kit..
The clamping method are screws. The same as the Holly carb.
You can add an aux venture if you want but the opening is a
venture,
The recess is to fit the 2 inch intake runner. It is tig welded.
Paul Lamar
Paul,
Are the ventures your bell mouths that you have on your web page? Joe
Berki
No. They must be machined into that front plate. You can do it with a
rotary table and a radius cutter.
Paul Lamar
Paul,
What is the thickness of the aluminum block that the body is machined
from? What radius did you specify for the venture? I ordered a
mixture kit from Tom. Joe Berki
I can't stand it any longer!!
Venturi Venturi Venturi
plural Venturis
Dave in Oz
Well said Dave. You must remember these guys speak AMERICAN not ENGLISH, it
is similar, not the same. LOL
Chris Hoskins. in NZ
I just had a long talk on the telephone long distance with a mover and
shaker in the
rotary world and he told me the drag racers are getting well over a 1000
HP out of a two rotor
on Methanol. I thought they were burning nitroglycerin :-)
Paul Lamar
------------------------------------------------------------------
Please add your questions or comments at the end of the thread.
Not the beginning.
I am going to enforce that rule. If people don't do that it will not be
forwarded.
My ISP changed the rules.
The Rotary Engine free News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove you. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Copyright
1998-2017 All world wide rights reserved.