Subject: Removing the inconel exhaust insert 12
From: paul lamar
Date: 11/26/2017, 12:00 PM
To: A10-Me-Earthlink

12

Hello Paul,

I have purchased a scratched out RX7 rotor housing . Got a good deal I think at £45 delivered. Just been having a look at it and surprised to find gap between port liner and rotary housing face. There are also two small holes in the upper corners of the port which allows exhaust to escape to a small lower exit. What was that for Paul ?

How would I best remove the port. I had thought before receiving the housing that I would have to cut it out but has anybody removed one with a puller ? Maybe it will just come out with a good shake :) ?

Mark Dillner

That is a very good question. There are two roll pins holding it in.


https://itstillruns.com/tips-techniques-removing-roll-pins-5731780.html

Quote:

"Drill and Tap

Small roll pins may be wedged tightly into place or there is no access from the backside of the hole. In such cases, the center of the roll pin may have to be drilled out with a carbide drill bit. Apply plenty of penetrating oil while you drill to act as a coolant. The center hole of the pin is then tapped so a bolt can be inserted. The bolt is then used to pull the pin from the hole. If the pin is too hard to tap, use a hardened, self-tapping screw. Drive the screw into place with a screwdriver. A slide hammer may have to be used to "knock" the bolt and pin assembly from the precision hole. You may have to modify the end of the slide hammer to accommodate the size of bolt or screw that was threaded into the center of the roll pin. Allow some time for the oil to soak through the sides of the roll pin and into the hole. The lubricant may help loosen the stuck roll pin before extraction with the slide hammer.


 Drill Out

Some roll pins may be so tight or rusted inside the hole that the only alternative is to completely remove the pin by drilling it out with a carbide bit. Caution must be exercised as the drill bit may attempt to wander off the center of the pin. This can cause a mis-centered or an oblong hole. Once the pin is removed, the hole can be re-drilled with a slightly larger bit. A larger roll pin must be inserted after the repairs are made."
End quote.

The passages heat the cool side of the engine to even the temperature. We found this unnecessary.

Since this is a scarp housing simply grind the roll pin out of the aluminum.


BTW Mark I found a new company in the UK doing rotary stuff.

www.polgain.co.uk


Paul Lamar


------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.