Subject: STEEL COUPLING WITH FRONT RING GEAR HUB 12 a
From: paul lamar
Date: 11/26/2017, 11:28 AM
To: A10-Me-Earthlink



   12 a

   Good morning paul


   i did work an other way to build a coupling by using the hub from the
   E4D trans front ring gear hub, the other part have to be machined from a
   steel bar.

   The flywheel need to be relocated adjacent to the counterweight and this
   new part

     and give more space between the flywheel and front plate.

   The steel block are hold by rivets and tig welded each side to hold the
   compression load.

   I am sending you some photos when i trimmed on the lathe with cutting
   wheel and the design.

   The rubber blocks are .750" thick.

   It might be interesting to the one who want to build it and save some
   machining by using the splines stell hub.

   Just an idea Paul

   That cut off grinder mounted on the tool post holder is a wonderful
   idea. Good work.
   Paul Lamar

Paul, and everyone,
Some years ago I mentioned that most modern motorcycles used a cushion drive hub at the rear wheel. At the time everyone was saying they wouldn't work, or other comments. SO now we are reinventing the wheel, or at least the wheel hub! If you must incorporate a damper it would be wise to look at the latest bikes. I have a brand new Aprilia Tuono that uses a bolt on rear wheel shock damper. It could literally be bolted onto one of the hubs we are using.


This isn't even unique as the latest Yamaha 1000cc R1s have a similar arrangement. These designs are designed to live with the output of 200+ HP engines and the shock loads of a gearbox shifted by less than perfect humans. The sport type liter bikes are all approaching the 200 MPH mark for top speeds and if my old calculations are correct I believe that requires about 400 lbf at the sprocket. Work I'm doing on a reduction drive planning for 400 HP at 7000 RPM works out to 300 lb/ft of torque.


My point is that these drives are available at motorcycle salvage shops now. Some of the lightest versions look to be lighter than any of the dampers the guys on the newsletter are building. Custom machining and casting parts might be needed for a super turbo engine, but for those of us just looking for alternate power the rear wheel dampers might be just the ticket, without expensive machining. They come with their own replaceable rubber, or silicone dampers. Some are harder and may be urethane.
Bill Jepson

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.