12 a
Hello Paul,
I have purchased a scratched out RX7 rotor housing . Got a good deal
I think at £45 delivered. Just been having a look at it and surprised
to find gap between port liner and rotary housing face. There are
also two small holes in the upper corners of the port which allows
exhaust to escape to a small lower exit. What was that for Paul ?
How would I best remove the port. I had thought before receiving the
housing that I would have to cut it out but has anybody removed one
with a puller ? Maybe it will just come out with a good shake :) ?
Mark Dillner
That is a very good question. There are two roll pins holding it in.
https://itstillruns.com/tips-techniques-removing-roll-pins-5731780.html
Quote:
"Drill and Tap
Small roll pins may be wedged tightly into place or there is no
access from the backside of the hole. In such cases, the center of
the roll pin may have to be drilled out with a carbide drill bit.
Apply plenty of penetrating oil while you drill to act as a coolant.
The center hole of the pin is then tapped so a bolt can be inserted.
The bolt is then used to pull the pin from the hole. If the pin is
too hard to tap, use a hardened, self-tapping screw. Drive the screw
into place with a screwdriver. A slide hammer may have to be used to
"knock" the bolt and pin assembly from the precision hole. You may
have to modify the end of the slide hammer to accommodate the size of
bolt or screw that was threaded into the center of the roll pin.
Allow some time for the oil to soak through the sides of the roll pin
and into the hole. The lubricant may help loosen the stuck roll pin
before extraction with the slide hammer.
Drill Out
Some roll pins may be so tight or rusted inside the hole that the
only alternative is to completely remove the pin by drilling it out
with a carbide bit. Caution must be exercised as the drill bit may
attempt to wander off the center of the pin. This can cause a
mis-centered or an oblong hole. Once the pin is removed, the hole can
be re-drilled with a slightly larger bit. A larger roll pin must be
inserted after the repairs are made." End quote.
The passages heat the cool side of the engine to even the
temperature. We found this unnecessary.
Since this is a scarp housing simply grind the roll pin out of the
aluminum.
BTW Mark I found a new company in the UK doing rotary stuff.
www.polgain.co.uk
Paul Lamar I found the best method if you have a TIG welder is to
simply start to weld with a 1/16" ss rod..... but then just stick the
rod on the roll pin end. Then while still hot the pin slides out
with pliers.
Barry Bordes
So you use a SS rod instead of tungsten and the SS rod sticks to the pin.
You then remove the rod from the torch and pull the rod and pin out
together?
Is that is how it is done?
Can you take some pictures or shoot a movie?
Paul Lamar
------------------------------------------------------------------
Please add your questions or comments at the end of the thread. Not
the beginning.
I am going to enforce that rule. If people don't do that it will not
be forwarded. My ISP changed the rules.
The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.