12


Paul

You forget about the bolting attachment of the Ford drum plate to to your design which is additional weight , to compare with my design is close to your design weight.

I will send you the design later.


Jean Proudhomme

I don't use that Ford part. I fasten the sun gear to the hollow  1.5 inch input
shaft with extended point set screws. They work like splines but
are much lower cost.  Tracy used a pin to fasten the sun gear to a one
inch shaft. That failed on Dave Leonard's turbo. It was also welded.

I think you where on the News Letter when that happened.

This is much stronger.


Here it is complete with sun gear.

Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.