Subject: Machining sun gear for set screws 12 b
From: paul lamar
Date: 12/9/2017, 6:49 PM
To: A10-Me-Earthlink



12 b

The sun gear seems too hard to turn, drill and tap. How do you machine
it for set screws?

Paul Shamlian

You can grind the teeth off with a grinder mounted on the tool post holder
on a lathe.

It can  be drilled with a carbide drill.

  Get it red hot on the back end with a torch and bury it in sand so it
cools slowly.

Do one or two holes at a time. The stress is very low.

Paul Lamar

--------------------------------------------------------------

Here is an even better way.
Just drill twelve  .25" diameter  holes through the gear and  .15 inch deep in the hollow input
shaft.  Then drop in 12 short pins and tig weld all of them.
Equivalent in strength to extended point set screws.
Same principle.


Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be
forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.