Subject: Even lower cost and lighter way of attaching a flange to a shaft 12
From: paul lamar
Date: 12/11/2017, 2:15 PM
To: A10-Me-Earthlink

12

This uses the extended point set screw method or idea except
long 1/4 inch rods are used instead of set screws.

The shorter rods that pass through the bolt holes do not have to be
tig welded. The bolts will hold them in place.

This is at least twice as strong as merely tig welding the flange
to the shaft. The flange can still be tig welded but should only
be done on the no load end. The back side in other words.

This is a major trick and it will go down in history  long after
I am dead :-)

Paul Lamar


------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.