Subject: Trouble with the TTC water injection. 12
From: paul lamar
Date: 12/14/2017, 7:46 PM
To: A10-Me-Earthlink

12

First we had trouble with the Oz M&W CD ignition.
Since we have no alternator or voltage regulator
the battery voltage would drop below 11 Volts
and the Oz ignition would quit.

We got the first indication of this up at Cal City
after the first test  flight.

We checked around and found that the drag racers
used an 18 volt battery for just the ignition as they
don't run an alternator either.

We found a small 20 volt battery and installed that just for
the ignition.

Unfortunately the wire that fed the ignition also fed
the water injection solenoid. That caused a transistor inside
the Motec 800 to fail as 20 volts on a 15 ohm solenoid caused
a current  1.33 AMPs. Ouch!

If the water injection fails the air intake temperature goes
to 300 F probably raising the rotor temperature to well over
500 F. Now that could melt the side seals if you are not
using Teflon encapsulated side seal O-rings. I think
we are seeing signs of that now. The stock seals
o-rings are not up to it. I had a Cosmo that had melted
side seal O-ring that smoked like made on start up
but I drove it for ten years like that.

Back to todays problem.
We reduced the voltage on the solenoid to 12 volts.

Worked for a flight or two and then we failed another
transistor in the Motec 800.  We were going to run out
of transistors soon. I measured the ohms on the old solenoid
and found it to be 12 ohms. Apparently some of the coils
had shorted. We bought a new one and that was back up
to 15 ohms.

Well that is still  .8 amp. Quite a lot for 8 or 10 year old Motec
800 transistors. Modern transistor in the last few years are
far more efficient as they are used in LED lighting and everything
else including cell phones and computers.

So today's mod was use a 5 ohm 10 watt resister in series
with the 15 ohm solenoid to reduce the transistor current
to .6 amps. If the second to last transistor fails we may need
to get the Motec 800 repaired.

I did not take the Motec apart to check the transistors or
change the transistors for more modern versions  but I probably could
if needed.


Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.