Subject: PSRU input shaft oil seals 12
From: paul lamar
Date: 12/19/2017, 10:09 AM
To: A10-Me-Earthlink

12


    Wasn't there a viton seal recommended to seal the bearing/thrust washer stack against the motor mount plate?

    Alex Molteno


    Yes but I recommend something better.
    Teflon.

    Paul Lamar

For the oil seal, my original oil seal supplied with the motor mount adapter plate is 1.5" OD and 1" ID. McMaster Carr doesn't carry Teflon seals in this size. Does anyone have another source for PTFE rod/shaft seals?

Alex Molteno

No problem. Jean or I (when I get back) can cut a reducer ring that can be
pressed in the PSRU adapter plate to reduce to OD of seal to the more common 1.25 inches.
Jean has a lathe.  I'll try to visit him before the 6th.

Warm the PSRU adapter plate in the oven to 200 F
and cool the adapter in the freezer.

These seals are rare and it is tough to find another source. Their out there but they
may be custom. Even more expensive :-)

Paul Lamar


------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.