12 e
Wasn't there a viton seal recommended to seal the bearing/thrust
washer stack against the motor mount plate?
Alex Molteno
Yes but I recommend something better.
Teflon.
Paul Lamar
For the oil seal, my original oil seal supplied with the motor mount
adapter plate is 1.5" OD and 1" ID. McMaster Carr doesn't carry Teflon
seals in this size. Does anyone have another source for PTFE rod/shaft
seals?
Alex Molteno
No problem. Jean or I (when I get back) can cut a reducer ring that
can be
pressed in the PSRU adapter plate to reduce to OD of seal to the more
common 1.25 inches.
Jean has a lathe. I'll try to visit him before the 6th.
Warm the PSRU adapter plate in the oven to 200 F
and cool the adapter in the freezer.
These seals are rare and it is tough to find another source. Their
outgo
there but they may be custom. Even more expensive :-)
Paul Lamar
Search SKF seals, They purchased Chicago Rawhide one of the worlds
biggest seal manufacturers. Their site isn't easy to navigate, but they
have loads of seals in both metric and english sizes. All types of
material. They have many sales outlets. I have been getting my seals
from a local Motion Industries outlet.(California) For our friends Down
Under A - Z, SKF has outlets around the world and you can search for
local outlets on their site. Probably considerably cheaper than McMaster
Carr too!
Bill Jepson
I saw them but their web site sucks :-)
The catalog is complicate and without prices.
If you go through Motion you have to get a quote. No prices
and not in stock.
Mc Master is quick and to the point.
Paul Lamar
Ok thanks Bill, I'll Check out SKF as well
Alex Molteno
Paul,
I agree about the SKF web site. It was done by a 2 year old with a
crayon. But if you can struggle through there are lots of things to be
found. McMaster is a excellent resale company and their site is great,
but they are just a stocking reseller and if you find the company that
made the parts they are selling you find they are frequently marked up
100% over a regular outlet. I still use them frequently for the
convenience as long as you know that you will be paying for it.
Bill Jepson
What I don't like about Motion is they don't stock the things that I need.
I wanted some bearings for a gear box prototype I am working on and
it takes 3 weeks to a month to get them. I think they wait until some
one else orders the same thing. The bearings were not cheap :-)
I suspect this is partially due to the reduction in developing new stuff
in the U.S.
We are losing the infrastructure required for manufacturing. Bearing
manufacturing
is now done over seas. SKF is a good example.
Paul Lamar
------------------------------------------------------------------
Please add your questions or comments at the end of the thread.
Not the beginning.
I am going to enforce that rule. If people don't do that it will not be
forwarded.
My ISP changed the rules.
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.