Subject: How is a Wankel combustion chamber related to wing. 12 c
From: paul lamar
Date: 3/4/2018, 5:16 PM
To: A10-Me-Earthlink


12 c

I found a old book called "Visions of a Flying Machine" by Peter L.
Jakab. Published by the Smithsonian. 1990 ISBN 0-87474-456-3


It is about the Wright brothers thinking as they developed their
flying machine.

Several books about the Wrights mention the problem of a movement in
the center of pressure on a wing as it changed angle of attack. This
book discusses that in detail.

It occurred to me that perhaps the same thing was going on in the
Wankel combustion chamber. The implication of that is it affects th
torque and efficiency.

Piston engine analysis assumes the center of pressure is at the
center of the piston. Unlike the Wankel the piston engine has no
lateral blast of air. A wing is subject to the same blast. I suspect
the squish flow is affecting the movement of the center of pressure
in the combustion chamber. I don't recall ever reading that in
technical papers about the Wankel. I suspect it has been assumed the
center of pressure is located at the center of the rotor face.

The University of Vienna paper on the Wankel is using CFD is the
best so far. I suspect improvements in CFD could quantify and
determine the dynamic center of pressure to recalculate the torque as
a function of engine rotation. Then the idea is fix it.

Paul Lamar

Hi Paul Maybe I have this wrong but I was  under the impression that
the high speed air during the compression and ignition period was in
relation to the stationary housing and spark plugs where as the
rotor is generally moving with the air stream. the primary air
movement relative to the rotor would be from vortexes generated by
the changing geometry of the intake port as the rotor opens and
closes it. Regards Bill  McDonald

The air is flowing faster than the rotor face is moving.
Particularly at low RPM and small throttle openings  where the BSFC
is worst.

Paul Lamar

Paul, a couple of things to note.
The Mazda housing showing burn rate  is the early version.  The present REW and RE have the leading plug about 7mm lower to improve its burn rate.  Mazda found that when the flame fronts collide the rate slows. Hence the 16X dimensions mimic the early 12A ratio.

Notice also that Austro has a problem with the double hump burn rate and slow ignition . Timing has to be retarded to 6deg ATDC . This is a result of having their plugs next to each other.
One last note. The leading, trailing and middle rotor trenches were tested by Mazda with the center version getting the nod.

..maybe one more observation.  The Mazda burn rate is not double humped.

Barry Bordes

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not
be forwarded. My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/You Tube
http://tinyurl.com/beqqxas Copyright 1998-2018 All world wide rights
reserved.






<1-Squish-flow-Fig-28.jpg <2-Squish-flow-2-fig-32.jpg
<FLAME_SPEED.JPG <Norbye-flame-propagation-P258.jpg
<Norbye-gas-velocity-P259.jpg <wind-speed-in-combust-chamber.jpg