Subject: NTSB Report on Turbine failure 12 b
From: paul lamar
Date: 3/14/2018, 8:20 AM
To: A10-Me-Earthlink


12 b

Paul, et al:

From the NTSB report [WPR16LA088]:

The pilot reported that he initially purchased the engine in 1999
from Atkins Rotary, located in Eatonville, Washington, and that there
were no historical records available for the engine. The pilot
subsequently installed the turbocharger to the engine, with its first
flight being in 2003.


This is the interesting read from Hartzell:

https://dms.ntsb.gov/pubdms/search/document.cfm?docID=450749&docketID=59730&mkey=92906

 -----

It appears that he exceeded the EIT (Exhaust Inlet Temp) of 1650F. He
had an EGT set to warn if the Exhaust temps got to 1600F.

Not being a turbo-charged engine operator, and knowing that this ATP
was attempting to turbo normalize for 5000 MSL = SL, my question is,
is it this easy to get into over-speed/over-temp conditions?

Regards, Steve Thompson

Tom Parke's engine is a 3 rotor. That is a lot of hot exhaust gas.
With a rotary it is wise to use a very large turbo as a given amount
of hot exhaust gas will do less damage to the turbine. We use a large
GT 40 on the two rotor. Tom's is an older turbo charger as well. I
would not be surprised if the turbine was not made from the best
material now available.

Tom also had a temp exhaust gas sensor but for some reason he did not
see the warning. The turbine might have been damaged earlier and Tom
did not notice it.

Paul Lamar


Paul,
From the pictures My guess would be FOD from the exhaust manifold/ header coming apart or something coming out of the exhaust port damaged the turbine wheel.
The turbine housing AR being 1.58 is large but more appropriate for a two rotor.
The turbine wheel appears to be inconel but has heat and FOD damage.
Has the engine been inspected?
Did the pilot feel it was partial loss of power or was it more of a substantial loss.
Second guessing after the emergency... Does the pilot think he might  have continued around the pattern on this reduced power? (Wondering how badly the three rotor is damaged).
Barry Bordes


Not FOD. FOD must go through the engine and small FOD (from a broken steel or iron apex seal)  has a different look.

Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread.
Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded.
My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2018 All world wide rights reserved.