Subject: Gill aircraft batteries 12 b
From: paul lamar
Date: 3/26/2018, 8:03 AM
To: A10-Me-Earthlink



12 b

I have a Gill  G-35 in the C182

I took it out and checked the battery voltage. It was down below 4.5
volts.

Aircraft Spruce wants $231 dollars for a new one.

The acid level was a little below the top of the plates.

I added a little water to each cell.

I hooked up the battery charger and very little current flowed. I
left it charging for 18 hours. Voltage is now over 12 volts and
charging current is 10 amps.

I was blown away. That battery sat around for years.

I'll learn more when I start the engine with it.


Paul Lamar

--------------------------------------------------------------------------------------


Well I hooked everything up including my 200 amp battery charger. It puts
out 200 amp to aid in starting so it claims. It works on the TTC
engine.

In this case the O-470 engine turned over very slowly while the pre
oiler was running. The Gill measured over 12 volts just before I
tried to turn the engine over.

No question of starting.

It could be a lead acid battery that measures the correct voltage
will not put out the current. I don't know of this and never heard
about it.

Looks like I will need to buy a 12 volt battery from Walmart and see
how that does. The prop rotation was so slow I could have turned it
by hand.

After this was all over I checked the Gill battery again and it was
over 12 Volts. I am a bit mystified.

Paul Lamar


Paul, maybe this will clear some of the mystery. Any lead-acid cell will charge to 2.1 volts, so 12.6 for six of them. When a lead-acid battery fails, as yours has, but none of the cells are shorted, you still get 12 volts but the internal resistance is so high that you can’t get any current out of them. Think of an AAA cell and a D cell. They both measure 1.5 volts but you can get about a half an amp from one and 20 amps from the other, due to internal resistance (and capacity, of course, which determines how long you can pull that amount of current.)

An O-470 starter wants about 500 amps.

David Josephson



That sounds like the answer. The internal resistances drastically increased. It is not enough
to measure the voltage. You have got to find out how much current it will put out.
Is there a way to fix that? Is that what sulfating is all about? I did notice the battery got
real warm when I was charging it. Is that a clue?

Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread. Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded. My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off the list PLEASE let me know and I will remove  you.

ACRE NL web site. http://www.rotaryeng.net
You Tube  http://tinyurl.com/beqqxas or PaulLamar2
Copyright 1998-2018 All world wide rights reserved.