Subject: Gill aircraft batteries 12 b2
From: paul lamar
Date: 3/26/2018, 7:51 PM
To: A10-Me-Earthlink




12 b2


I have a Gill  G-35 in the C182

I took it out and checked the battery voltage. It was down below 4.5
volts.

Aircraft Spruce wants $231 dollars for a new one.

The acid level was a little below the top of the plates.

I added a little water to each cell.

I hooked up the battery charger and very little current flowed. I
left it charging for 18 hours. Voltage is now over 12 volts and
charging current is 10 amps.

I was blown away. That battery sat around for years.

I'll learn more when I start the engine with it.


Paul Lamar

--------------------------------------------------------------------------------------


Well I hooked everything up including my 200 amp battery charger. It puts
out 200 amp to aid in starting so it claims. It works on the TTC
engine.

In this case the O-470 engine turned over very slowly while the pre
oiler was running. The Gill measured over 12 volts just before I
tried to turn the engine over.

No question of starting.

It could be a lead acid battery that measures the correct voltage
will not put   out the current. I don't know of this and never heard
about it.

Looks like I will need to buy a 12 volt battery from Walmart and see
how that does. The prop rotation was so slow I could have turned it
by hand.

After this was all over I checked the Gill battery again and it was
over 12 Volts. I am a bit mystified.

Paul Lamar


My Gill did the same thing, showed over 12 volts but failed on
delivering any amps, I used to have to hand prop the Pacer, once you
replace it your worries will go away. I also bought an el cheapo
cigarette lighter volt/ammeter on Amazon to see how the new battery
does, and it confirmed no voltage regulator issues and normal current
draw for everything except the landing light on my Pacer, so there's
a wiring issue on that circuit that I will fix when I next have time


Alex Molteno

Paul,

I’ve found that my deep cycle trolling motor batteries would only
last about two years.

I also discovered that if I use a small charger called a “Battery
Minder” the interval would increase to about six years.
It will usually charge a battery back to 12 V within 24 hours if everything is healthy. At that time it starts blinking showing that it is using a pulse charge that supposedly destroys the sulfurdatian on the plates.
It was on special for about $39 at Northern Tool?
Works great for me.
Barry Bordes


------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread. Not
the beginning.

I am going to enforce that rule. If people don't do that it will not
be forwarded. My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.

ACRE NL web site. http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas or PaulLamar2 Copyright 1998-2018 All
world wide rights reserved.