Subject: My rotary powered RV4 needs an ignition system. 12
From: paul lamar
Date: 3/27/2018, 1:55 AM
To: A10-Me-Earthlink

I could buy an OZ M&W for about $1000 or build my own.
The M&W is designed to be used with the $3000 Motec computer EFI system.
Also the M&W quits if the Voltage drops below 11 volts.
That was a gotcha on the TTC as the TTC uses the M&W.

I had the idea of using one 300 volts supply and two coil
triggers. The coil triggers fire 180 degree out so that gives time
to recharge the dual 300 volt capacitors. The coils are waste spark so they will fire the
upper and lower spark plugs at the same time. A total of only two coils.

No computer is needed if you use two CAS's mounted on the front
of the engine. Joe Berker is working on the needed dual CAS's mountings.
This will work with carbs.

Dual Hall effect sensors could be used so two CAS LM1815 conditioning
IC's can be done away with further simplifying the PC board.

Nothing trick here. Old tried and true tech.

Here is all the info I have so far.  The PC boards are being designed
and I need to buy 3 at a time.


Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread. Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded. My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off the list PLEASE let me know and I will remove  you.

ACRE NL web site. http://www.rotaryeng.net
You Tube  http://tinyurl.com/beqqxas or PaulLamar2
Copyright 1998-2018 All world wide rights reserved.