Subject: The key to the time to climb engine 12
From: paul lamar
Date: 4/6/2018, 3:37 PM
To: A10-Me-Earthlink

12

The turbo Wankel so far has not been very successful.

That includes the 3rd gen RX7.

IMHO it is because they are using iron or steel apex seals.

The normally aspirated seals run 500 F at high power.


Silicon nitride ball bearings are good to 1000 degrees Fahrenheit while steel ball bearings are limited

to 500 degrees Fahrenheit.

The normally aspirated stock cast iron apex seals operate at 500 F. Probably much higher
when turbo charged.

The main purpose of the apex seal oil mixed with the fuel is to cool the apex seals.

\These Iannetti ceramic apex seals are the key to turbo charged Wankel engines.
 If you turbo charge a Wankel with cast iron or steel apex seals it will probably fail.

Don't try to turbo with out Iannetti ceramic seals.


Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread. Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded. My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off the list PLEASE let me know and I will remove  you.

ACRE NL web site. http://www.rotaryeng.net
You Tube  http://tinyurl.com/beqqxas or PaulLamar2
Copyright 1998-2018 All world wide rights reserved.