12

Paul I have been trying to find the factory dimensions for the bearing surfaces
of the Renisis e shaft with no luck at all.
I have found a retired engineer happy to make me a single rotor
 e shaft but I do need these measurements to be spot on. Do you or
any of your subscribers have these details to hand. Need rotor and
main bearing surfaces factory measurements.
Hope someone could help
Mark Dillner


Most people start with a 2 rotor shaft and cut it down.
That saves some heat treating and grinding.

I don't have a mic that will go that big and I don't have
an RX8 shaft. I have some older shafts but if your building
a one rotor it probably does not matter as there are only
minor differences in length.


Will you be at Aero?

Paul Lamar


------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread. Not the beginning.

I am going to enforce that rule. If people don't do that it will not be forwarded. My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off the list PLEASE let me know and I will remove  you.

ACRE NL web site. http://www.rotaryeng.net
You Tube  http://tinyurl.com/beqqxas or PaulLamar2
Copyright 1998-2018 All world wide rights reserved.