Subject: Replacing an 0-200 with rotary engine
From: paul lamar
Date: 12/2/2018, 8:10 AM
To: A10-Me-Earthlink



Dear Paul,

Writing from the UK. Hopefully using this email as newsletter address correctly.
After reading your web page I am really interested in wankel rotary engines.
Would like to replace a Continental C-90 [90 HP] with one but not sure of the all up
weight of the mazda rotary with gearbox.
The other option is a second hand Midwest rotary engine, which  is available which would seem to be a really good replacement but would need stripping and rebuilding. Believe this is based on the Norton motorbike engine. This engine company was bought by Diamond aircraft but cannot get a reply from them regarding spares. Are there plans or kits available for the mazda conversions?
My thanks for your time.
Best regards
Bruce Keeping

-- 
Bruce Keeping

A one rotor normally aspirated Mazda with cast iron end housing and 120 HP would weigh more
than 200 pounds depending on the gear reduction type used.

Here is a version by Richard Sohn with aluminum end housing that weighs less than
200 pounds.


Richards email address is :

Richard Sohn <res12@fairpoint.net>

Paul Lamar

------------------------------------------------------------------
Please  add your questions or comments  at the end of the thread. Not the beginning.

I am going to enforce that rule. If people don't do that it will not be published. My ISP changed the rules.

The Rotary Engine free News Letter. Powered by Linux. If you want off the list PLEASE let me know and I will remove  you.

ACRE NL web site. http://www.rotaryeng.net
YouTube  Key word "PaulLamar2". Keep clicking
this as Youtube will try to divert you to advertising.
Copyright 1998-2018 All world wide rights reserved.