12 a
Hey Paul, the data is on for f1 engines is on wikipedia and several f1 websites
reporting similar power to weight ratios, the newer f1 power packages are heavier
obviously. The twisted e-shaft is on a rotary forum but also my buddy John broke one
in his sandcar I can see if he still has his, I just googled everything. I have been
seriously looking at putting a all alluminum rotary in the rv6 its ready for the
engine airframe, canopy, wings, everything is done so I have been doing a lot of
research and inquiries lately if we didnt already have a built 540 for the rocket
would be tempted to go rotary on that but I think the rv6 with its wider fuselage wil
make a nice canidate plus.
https://en.wikipedia.org/wiki/Power-to-weight_ratio
Thanks, Jacob Sturgis
That BMW weight and power was probably a lie :-) I am sure nobody would be allowed
to take it out of the car and verify the bare weight and power,
An older 19,000 RPM F1 engine probably used Beryllium aluminum pistons now out lawed
in F1. If we used Beryllium aluminum rotors in a Mazda Wankel we could double the
RPM, the
power to weight ratio and the HP. The empty weight would be much lower as the cast
iron rotors are
now 9 pounds each.
The big problem, for F1 engine use in an AC, is too high RPM. To get the prop RPM to
be a useful 2600 RPM would require a 7.3 to one gear box. Our 50 pound gear box is
only 3:1 which is about as high as you can get
with only one set of gears. Going to 7:1 or 8:1 would probably require several stages
of gears and would weigh well over 100 pounds.
I doubt any F1 engine would run at full power 2 minutes at a time
for a dozen times like we did with the TTC engine. Usually the older engines made
only one race.
Lets talk about cost. A F1 engine is close to 100 million dollars.
Paul Lamar
Hi Paul,
That is a very impressive list. Thank you publishing it here.
The other aspect that of efficiency is not listed.
Most likely it will be the same order with the most efficient engine on top, the
Waertsila 14 Cylinder which is near 52% peak at ideal condition.
Depending on use one or the other is of prime importance.
For planes and racing low weight dominates, for ships and transport high efficiency
does.
Rolf Pfeiffer
I doubt that 52% number because it does not look like they are recovering from the
Exhaust
Paul Lamar
-----------------------------------------------------------------
Please add your questions or comments at the end of the thread.
Not the beginning.
I am going to enforce that rule. If people don't do that it will not be published.
My ISP changed the rules.
The Rotary Engine free News Letter. 750 subscribers world wide.
Powered by Linux. If you want off the list PLEASE let me know and I will remove you.
ACRE NL web site.
http://www.rotaryeng.net
YouTube Key word "PaulLamar2". Keep clicking
this as Youtube will try to divert you to advertising.
Copyright 1998-2019 All world wide rights reserved.