Subject: Simple mechanical fuel injection.
From: Rotary Engine
Date: 5/27/2007, 6:44 AM
To: AARotary Engine



     >
     > thing about CV (constant velocity or constant depression) carbs is
     > that they meter fuel very precisely under all conditions, the next
     > best thing to EFI.


    Hi Paul, Matt, Gordon, and All

    IIRC, CV= 'constant vacuum' or "constant depression" (ie pressure)

    Also, I have seen the float chamber tube connected to the inlet
    manifold via the screw needle valve, rather than to the carb venturi.
    for a more stable vacuum source.

    Slide/needle carbs tend to have a higher flow for a given bore size
    because they do not have a butterfly in the airflow; only a slim
    needle. According to Mikuni they also have a natural leaning tendency
    with increase in altitude similar to CD carbs; up to about 10K feet.
    I like their simplicity, like the PL slide throttle FI. but no reams of
    R and D to get through!

    FWIW, Dave McC


    Dave,

    I thought about manifold vacuum and that might work. The venturi
    vacuum is a stronger signal though. If manifold vacuum does work
    though, you may be able to use this leaning scheme with Webers too.

    Yes the flat-slide and round-slide carbs are simple and good and
    they flow better than "constant pressure" carbs because the slide is
    actuated directly by the throttle. On constant pressure carbs the
    throttle is connected to a butterfly valve downstream of the venturi
    -- and the slide is opened against a spring by manifold pressure.

    That's why they are constant pressure, because the slide changes the
    venturi size to keep the pressure in the venturi the same at all
    throttle positions. The main needle is connected to the slide, so as
    the slide opens more fuel is drawn in.

    Both types have natural altitude compensation up to about 10,000
    feet as you pointed out because of the variable venturi. Both types
    will work fine on a rotary aircraft engine, just like they do on
    Rotaxes. And the manual mixture system will work equally well on both.

    I'm sending Paul a flow test I found on several Harley carbs,
    including Mikuni flat-slide and Keihin CVs in different sizes. The
    flat-slide Mikunis flow the best and can be had in 48 mm which is
    big enough for the P-port.

    Sorry Paul, the carbs I have are Bing 36mm, way too small for the
    rotary. For experimentation purposes I would pick up a pair of 44mm
    Mikuni VMs, which are round slide models with the slide directly
    actuated by the throttle. You can get these on ebay for less than
    $100. They may cause a bit of a pressure drop with 1 7/8 manifold
    runner, but not much.

    If I were building a cheap engine I would go this way. You are
    limited to 7500 rpm because of gearbox anyway, so I think the 44mm
    would not cost you much power. The 48mm Mikunis will definitely give
    you all the power the engine will make.

    Regards,

    Gordon.

Here is what I got Gordon. A couple of NTSB reports on failed carbs.
I have had my problems with aircraft carbs as well. Most had thousands
of hours on them.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.