I have ordered this ARM board to build a EFI system around, written in ARM
  compiled
  BASIC.

  It should be here in a few days DHL.

  We shall see how it goes.

  I should have something running in about a week.

  Paul Lamar

 Paul,

 Could you give us the info on this board so we could consider buying one
 also.

 I am thinking of some developments to our robotics products.

 Zoltan


 Here is the ARM board. It has infinite expansion potential.

 http://www.mikroe.com/eng/categories/view/16/arm-development-tools/

 I am working on two systems. I am working on a parallel approach as well
 with
 a real simple and old CPU (8051 not a C8051) controlling mostly hardware.

 If you are interested in the simple system let me know. It will very
 limited but it
 is quicker to build and program I hope. I will be testing some of the
 hardware in a
 few days. I'll know then if it is going to work.

 Paul Lamar

We would like to build two all aluminum engines to direct drive two ducted
fan propellers.

Probably two rotors in each engine, possibly three.

We need fuel injection and ignition control.

We have some robotics products, force sensors and motor controllers, these
could potentially benefit from ARM processors.

I need to learn about the programming of the ports.

Zoltan

You will need to down load this file.
www.ti.com/lit/ds/symlink/lm3s9b95.pdf

It is a very big file at 7.3 meg so I cannot email it.
It is 1399 pages. You will need a pdf editor that can extract a range of pages to
make it readable. Here is the analog to digital section alone.

Paul Lamar
-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.